Next post

A Shinobi monitor showing a false color exposure map of a portrait on a camera rig
Two NP-F batteries and a USB-C power bank laid out next to a 7 inch monitor

How to Power an Atomos Shinobi: NP-F, USB-C PD and Hot Swap

How an Atomos Shinobi is powered, how hot swapping works on the 7 RX and how to plan batteries for a long shoot.

An Atomos Shinobi runs from an NP-F battery or from USB-C Power Delivery, and the Shinobi 7 RX takes two NP-F batteries at once. For a long shoot, use two NP-F batteries on the 7 RX and swap one at a time; for a short job or a studio, a USB-C power bank or wall adapter is enough. Batteries, chargers and the AC adapter are not included in the box, so plan them when you buy.

The power options on a Shinobi

All Atomos Shinobi monitors support three ways of getting power:

  • NP-F battery. A Sony L series type battery. Atomos recommends these for field use because they power the monitor through long shoots without frequent swaps. Purchased separately.
  • USB-C Power Delivery. Power the monitor directly from a compatible power bank, wall adapter or hub. The Shinobi 7 II lists a 45W capable supply for USB PD input.
  • Battery eliminator. A dummy battery that fits the NP-F slot and powers the monitor from the separately available Atomos Locking AC Power Adapter. Useful for studio and long interview work.

The Shinobi II and Shinobi GO have one NP-F slot. The Shinobi 7 II has one. The Shinobi 7 RX has two.

Hot swapping on the Shinobi 7 RX

With two battery slots, one battery can be replaced while the other keeps the monitor running. The picture never drops, so there is no reboot between takes. This is the main reason people choose the 7 RX for events, long interviews and unpredictable days.

A habit that works: use both slots, and when the monitor warns that one battery is low, replace only that one. Charge the spare, and keep rotating. You never run both to empty at once.

Choosing NP-F batteries

Atomos lists NP-F and L series batteries as compatible with the Shinobi range. Capacity varies by battery, so check the rating printed on yours. Keep these points in mind:

  • Size. Larger NP-F numbers usually mean higher capacity and a bigger, heavier battery. Choose the largest that your rig can carry comfortably.
  • Brand quality. Unbranded cells can have inflated capacity claims. Buy from a reseller who stands behind them.
  • Charger. Check whether your batteries need a dedicated charger, and buy one that charges two at a time.
  • Age. Old batteries lose capacity. If one gives half the time it used to, replace it before an important job.

We do not quote runtimes here, because they vary with battery capacity, brightness and temperature. Test your own setup before a paid shoot.

Power bank or battery?

Option Good for Watch out for
NP-F battery Field work, gimbals, events Weight and charging between jobs
Two NP-F, hot swap (7 RX) Long days, no downtime Needs spares and a charger
USB-C PD power bank Travel, light rigs, backup Must support Power Delivery at the right wattage
Battery eliminator and AC adapter Studio, interviews, long sessions Tied to a wall socket

For a power bank, check that it advertises USB-C Power Delivery and enough wattage for the monitor. Atomos lists a 45W capable supply for the Shinobi 7 II. A plain phone charger may not be enough.

Cables and ports that matter for power

Use the USB-C cable Atomos supplies or another cable rated for the power you need, because a thin charging cable can limit the current. On the Shinobi 7 II, Atomos lists USB PD input as needing a 45W capable power supply. Keep the connector snug, and avoid routing the cable where it can be pulled on a gimbal. The Shinobi range is powered over USB-C but the same port may also carry camera control on supported models, so check which cable does which job before you tape it down.

Powering other gear from the monitor

The Shinobi 7 II lists a USB PD output of up to 13W. Do not count on charging a phone or other device from the monitor during a shoot unless you have confirmed it for your model, because draw from the monitor shortens battery life.

How to plan runtime without guessing

Runtime depends on four things: battery capacity, screen brightness, whether the camera control and wireless features are in use, and the temperature. You can find your own number in ten minutes of testing:

  1. Charge a battery fully and fit it to the monitor.
  2. Set the brightness you normally shoot at, and switch on the features you normally use.
  3. Note the time, and check the battery level after one hour.
  4. Multiply to estimate a full cycle, then keep a margin of at least a quarter.

Write the result on the battery with tape. A number you measured on your own kit beats any figure from a brochure.

Heat and power in an Indian summer

Atomos lists an ambient operating temperature of up to 40 degrees Celsius for the Shinobi II and Shinobi 7 II. A hot outdoor shoot with the screen at full brightness draws more power and warms the monitor, which shortens battery life. Keep the monitor shaded between takes, use a hood or a shade where you can, and avoid leaving it in a closed car. The Shinobi 7 II manages heat with an actively controlled fan, while the Shinobi II uses a passive heat sink.

A practical kit for each style of work

  • Gimbal or vlogging: a Shinobi II or GO, one NP-F and a small USB-C power bank as backup
  • Events and weddings: a Shinobi 7 II or 7 RX, two NP-F batteries, a dual charger
  • Studio and interviews: a 7 RX with a battery eliminator and the Atomos Locking AC Power Adapter, plus one NP-F for backup if the mains fails

Mistakes that end a shoot early

  • One battery, no spare. A single NP-F on a single slot means the monitor goes dark when it runs out. Carry a charged spare, or choose the 7 RX and keep a second battery in it.
  • Underpowered USB-C supply. A small phone charger may not keep the monitor running at full brightness. Use a supply that meets the wattage Atomos lists.
  • Charging on the day. Charge batteries the night before, not between takes. Label them in the order you will use them.
  • Brightness left at maximum. Full brightness draws the most power. Turn it down indoors and in shade, and your battery lasts longer.
  • No backup power. A small USB-C power bank in the bag can save an hour when a battery fails.

Protecting the kit

Batteries, cables and a monitor travel better in a case than loose in a bag. The Shinobi 7 RX from ShutterBuzz includes a free hard case. Read our hard case buying guide if you also carry batteries and cables. See the Atomos Shinobi 7 RX, the comparison with the 7 II, or the full range guide.

Frequently asked questions

Does the Atomos Shinobi come with a battery?
No. NP-F batteries and the battery eliminator are purchased separately. The Shinobi II box, for example, holds the monitor, a USB-C cable, an HDMI and USB-C locking cable adapter and a Quick Start Guide.

Can I hot swap batteries on the Shinobi 7 RX?
Yes. It has two battery slots. One battery can be replaced while the other keeps the monitor running.

Can I power a Shinobi from a power bank?
Yes, if the power bank supports USB-C Power Delivery and can supply enough power. Atomos lists a 45W capable supply for the Shinobi 7 II.

Will my existing NP-F batteries work?
Atomos lists NP-F and L series batteries as compatible, so a battery you already own is likely to fit. Check that it is in good condition and has enough capacity for your shoot.

Back to blog

Newsletter

Add subheading here

Tags

Social media